![]() Make sure you also go back to remap the buttons too. Only one of them should respond to that controller. Itll be hard to visually tell the difference between both controllers when wired in PCSX2, but you can just highlight one of the "DX Controller (XBOX 360 For Windows)"(Theres gonna be 2 of them) and "test the device". If you want to use wired option only then make sure you go check the checkbox for "DirectInput" and uncheck the checkbox for "Xinput" and click apply at the bottom. If youre using wired controllers then it would be "DirectInput" instead of "Xinput", though the controller should still be read as both if youre using DS4Windows. I derped when explaining the "other" option but basically after you created/have a profile already, open it and then the "other" option should be visible at the top right. Once done with "Xinput Pad 0" then test "Xinput Pad 1". The value should change when pressed from 0.000 to 1.000 if you mapped it properly and if theyre working. To test, in the "Generals" tab, highlight "XInput Pad 0" and click the "Test Device" option below. Once assigned then you can test them out. But also make sure your buttons is are properly assigned. By default they should work? At least from my experience it does. ![]() In the LilyPad settings(Config Tab>Controllers (PAD)>Plugin settings), make sure the "Xinput (Xbox 360 controllers only)" checkbox is CHECKED and click apply.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |